Whirlpool WDT705PAK Owners Manual - Page 11

Remove Access Panel - For Plastic Access Panels, go to step 9 - For Metal Access Panels, go to step 10 9. Plastic panel 11. Measure cabinet opening Using a flat-blade screwdriver, turn the plastic fasteners 1/4 turn counterclockwise to unlock them. Go to step 12. 10. Metal panel Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed. Be sure to measure the lowest point on the underside of the countertop and the highest point on the floor. Dishwasher Height Adjustment Chart Cabinet-opening Front legs height Rear legs height height A B 33 1/2" (851 mm) 3/8" (9.8 mm) Remove legs and spacers. 34" (864 mm) 7/8" (22 mm) 1" (25.4 mm) 34 1/2" (876 mm) 1 1/8" (28.8 mm) 1 1/4" (31.3 mm) Front legs - A Using a 1/4" (6.35 mm) nut driver or Phillips screwdriver, remove 2 screws attaching access panel to dishwasher. Rear legs - B Adjust both front and back leveling legs to the same height. NOTE: If the minimum cabinet opening height is less than 33 7/8" (860 mm), the rear leveling legs and spacers can be removed for additional clearance. This will allow the dishwasher to fit into a 33 1/2" (851 mm) high cabinet opening, but the dishwasher will be more difficult to move. (Measurements are approximate. Rear and front leveling legs are preset at the factory for 34 1/2" [876 mm].) 11