Whirlpool WDT705PAK Owners Manual - Page 13
Connect Fill Hose to Fill Valve, Drain Hose Connection, Power Cord Connection
View all Whirlpool WDT705PAK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Connect Fill Hose to Fill Valve 18. Tighten 90° elbow fitting to valve 21. Hose clamp final position Be sure rubber washer is properly seated in fitting. Slide the 3/4" (19 mm) fitting of the 90° elbow up to the valve and hand-tighten to avoid cross-threading. Hand-tighten until the coupling is tight. Using pliers, check the tightness of the coupling. An additional 1/4 to 1/2 turn may be required to seal the rubber gasket. Route fill hose out the rear left side of unit. NOTES: � Do not use PTFE plumber's tape with compression fittings. � Do not overtighten. Damage to the coupling can result. Drain Hose Connection 19. Connect drain hose NOTE: Route drain hose out the rear of the dishwasher. Power Cord Connection NOTE: If removing a previous dishwasher with a power cord, you will need to transfer the power cord to the new dishwasher. 22. Remove terminal box cover Using a 1/4" hex-head socket, nut driver, or Torx® T20® screwdriver, remove terminal box cover. Retain for later use. 23. Install strain relief Place towel under drain hose to catch any water in drain hose. Place the small (green) drain hose clamp onto the small end of the drain hose. Push the new drain hose into the rubber drain hose connector up to the drain hose stop. 20. Slide clamp onto connector Install the metallic strain relief provided in this kit (Straight: Whirlpool Part Number 4317824, 90°: Whirlpool Part Number W10278923RP). Make sure screw heads are facing to the left when tightening conduit nut. Strain relief is provided with the power cord kit. 24. Power cord - route cord into terminal box Using pliers, squeeze open the small drain hose clamp, and slide it onto the connector between stops. Route cord so that it does not touch dishwasher motor or lower part of dishwasher tub. Pull cord through strain relief in terminal box. NOTE: A maximum of 2 power cord supply conductors (12 AWG largest size) plus 1 grounding conductor are permitted in the terminal box. 13