Whirlpool WED70HEBW Installation Guide - Page 21

9. Reinstall inner door assembly Bottom of door Reverse door swing round-shaped door - double handle 1. Remove door from dryer Position the door with the inside of the door facing up. Reinstall the 10 screws securing the inner door to the outer door. 10. Reinstall door on dryer IMPORTANT: If the protective film has not yet been removed from the dryer, peel the film from the dryer door before proceeding. Using a TORX T25 screwdriver, remove the 4 screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Reinstall the 4 screws in the holes. 2. Move the door strike Using a TORX® T25 screwdriver, remove the 4 screws on the dryer. Insert the tabs on the hinge into the mounting slot and slide down to engage the top tab. Secure in place with the 4 TORX T25 screws removed earlier. Using a TORX T25 screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown. 21