Whirlpool WED92HEFC Installation Guide - Page 12
Optional External Ground for 3-Wire
View all Whirlpool WED92HEFC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
2. Remove center screw Remove center terminal block screw (B). 3. Connect neutral wire Place hooked end of neutral wire (white or center) (C) of direct wire cable under center terminal block screw (B), hook facing right. Squeeze hooked end together. Tighten screw. 4. Connect remaining wires Optional External Ground for 3-Wire Connection (Power Supply Cord Shown) IMPORTANT: You must verify with a qualified electrician that this grounding method is acceptable before connecting. 1. Prepare to connect neutral ground B wire and neutral wire E B A Install the correct strain relief for your electrical connection method, as shown on page 8 or 10. B Remove center terminal block screw (B). Remove neutral ground wire (E) from green external ground conductor screw (A). C 2. Connect neutral ground wire and neutral wire B E C Connect neutral ground wire (E) and neutral wire (white or center wire) (C) of power supply cord or cable under center terminal block screw (B). Tighten screw. 3. Connect remaining wires Place hooked ends of remaining direct wire cable wires under outer terminal block screws (hooks facing right). Squeeze hooked ends together and tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now go to "Venting Requirements." Place ends of remaining wires under outer terminal block screws. Tighten screws. 12