Whirlpool WEE760H0DS Use & Care Guide - Page 4

KEY USAGE TIPS AquaLift® Self-Cleaning Technology Ceramic Glass Cooktop Cleaning To avoid damaging the cooktop, do not use steel wool, abrasive powder cleansers, chlorine bleach, rust remover or ammonia. 1. Remove food/residue with the Cooktop Scraper. AquaLift® Self-Cleaning Technology is a first-of-its-kind cleaning solution designed to minimize the time, temperature, and odors that ordinarily come with traditional self-cleaning methods. With AquaLift® Self-Cleaning Technology, an innovative coating on the interior of the oven is activated with heat and water to release baked-on soil. To use AquaLift® Self-Cleaning Technology, simply wipe out loose debris, pour water into the oven bottom, and run the AquaLift® Self-Cleaning cycle. When the cycle finishes in under 1 hour at a lower temperature than traditional self-cleaning methods, just wipe out the remaining water and loose debris. See the "Clean Cycle" section for more detailed instructions. For additional information, frequently asked questions and videos on using AquaLift® Self-Cleaning Technology, visit our website at http://whr.pl.com/aqualift Surface Temperatures When the range is in use, all range surfaces may become hot, such as the knobs and oven door. Warming or Storage Drawer When the oven is in use, the drawer may become hot. Do not store plastics, cloth, or other items that could melt or burn in the drawer. Oven Vent The oven vent releases hot air and moisture from the oven, and should not be blocked or covered. Do not set plastics, paper or other items that could melt or burn near the oven vent. Preheating When beginning a Bake, Convect Bake or Convect Roast cycle, the oven will begin preheating after Start is pressed. The oven will take approximately 12-15 minutes to reach 350°F (177°C) with all of the oven racks provided with your oven inside the oven cavity. Higher temperatures will take longer to preheat. The preheat cycle rapidly increases the oven temperature. The actual oven temperature will go above your set temperature to offset the heat lost when your oven door is opened to insert food. This ensures that when you place your food in the oven, the oven will begin at the proper temperature. Insert your food when the preheat tone sounds. Do not open the door during preheat before the tone sounds. ■ For best results, use the Cooktop Scraper while the cooktop is still warm, but not hot to the touch. It is recommended to wear an oven mitt while scraping the warm cooktop. ■ Hold the Cooktop Scraper at approximately a 45° angle against the glass surface and scrape the residue. It will be necessary to apply pressure in order to remove the residue. Allow the cooktop to cool down completely before proceeding to Step 2. 2. Apply a few dime-sized drops of affresh® Cooktop Cleaner to the affected areas. ■ Rub affresh® Cooktop Cleaner onto the cooktop surface with the blue Cooktop Cleaning Pad. Some pressure is needed to remove stubborn stains. ■ Allow the cleaner to dry to a white haze before proceeding to Step 3. 3. Polish with a clean, dry cloth or a clean, dry paper towel. ■ Repeat steps 1 - 3 as necessary for stubborn or burnedon stains. The Complete Cooktop Cleaner Kit is available for order including the following: ■ Cooktop Scraper ■ affresh® Cooktop Cleaner ■ Blue Cooktop Cleaning Pads See the "Accessories" section for ordering information and part numbers. 4