Whirlpool WEG515S0FS Installation Guide - Page 11

Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light. The burner cap should not rock or wobble when properly aligned. A B A. Incorrect B. Correct WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 6. Plug into a grounded 3 prong outlet. Verify Anti-Tip Bracket Is Installed and Engaged 1. Slide range into final location, making sure rear leveling leg slides into anti-tip bracket. 2. Remove the storage drawer. See the "Remove/Replace Drawer" section. 3. Use a flashlight to look underneath the bottom of the range. 4. Visually check that the rear range foot is inserted into the slot of the anti-tip bracket. Electronic Ignition System Initial Lighting and Gas Flame Adjustments Cooktop and oven burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to the "ignite" position, the system creates a spark to light the burner. All cooktop burners will spark, but only the burner with the control knob turned to the "ignite" position will produce a flame. This sparking continues as long as the control knob is turned to the "ignite" position. When the oven control is turned to the desired setting, sparking occurs and ignites the gas. Check Operation of Cooktop Burners Standard Surface Burners Push in and turn each control knob to the "ignite" position. The flame should light within 4 seconds. The first time a burner is lit, it may take longer than 4 seconds to light because of air in the gas line. If Burners Do Not Light Properly: ■■ Turn cooktop control knob to the "off" position. ■■ Check that the range is plugged into a grounded 3 prong outlet. Check that the circuit breaker has not tripped or the household fuse has not blown. ■■ Check that the gas shut-off valves are set to the open position. ■■ Check that burner caps are properly positioned on burner bases. Repeat start-up. If a burner does not light at this point, turn the control knobs to the "off" position and contact your dealer or authorized service company for assistance. Please reference the "Warranty" section of the User Guide to contact service. If the cooktop low burner flame needs to be adjusted for any of the burners, see the "Adjust Flame Height" section. Check Operation of Oven Bake Burner 1. Press BAKE. 2. Press the Start pad. The oven burner should light within 8 seconds. The first time a burner is lit, it may take longer than 8 seconds to light because of air in the gas line. 3. After 2 minutes, open the oven door and check that the oven is warm. If Burner Does Not Light Properly: ■■ Press the Off pad. ■■ Check that the range is plugged into a grounded 3 prong outlet. Check that the circuit breaker has not tripped or the household fuse has not blown. ■■ Check that the gas shut-off valves are set to the open position. Repeat steps 1 to 3. If the burner does not light at this point, press the off pad and contact your dealer or authorized service company for assistance. Please reference the "Warranty" section of the User Guide to contact service. If the bake burner flame needs to be adjusted, see the "Adjust Flame Height" section. Refer to the User Guide for proper operation of the oven controls. Check Operation of Oven Broil Burner 1. Close the oven door. 2. Press BROIL. 3. Press the Start pad. The oven burner should light within 8 seconds. The first time a burner is lit, it may take longer than 8 seconds to light because of air in the gas line. 4. After 2 minutes, open the oven door and check that the oven is warm. If Burner Does Not Light Properly: ■■ Press the Off pad. ■■ Check that the range is plugged into a grounded 3 prong outlet. Check that the circuit breaker has not tripped or the household fuse has not blown. ■■ Check that the gas shut-off valves are set to the open position. Repeat steps 1 to 3. If the burner does not light at this point, press the Off keypad and contact your dealer or authorized service company for assistance. Please reference the "Warranty" section of the User Guide to contact service. If the broil burner flame needs to be adjusted, see the "Adjust Flame Height" section. Refer to the User Guide for proper operation of the oven controls. 11