Whirlpool WEG750H0H Instrucciones de instalacion - Page 17
To Convert Surface Burners Natural Gas to Propane, To Convert Oven Bake Burner Natural Gas to,
View all Whirlpool WEG750H0H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
3. Remove plastic cover from gas pressure regulator cap. 4. Turn gas pressure regulator cap counterclockwise with a 5/8" (16 mm) combination wrench to remove. NOTE: Do not remove the spring beneath the cap. Side view before A 4. Remove the orifice spuds shipped in the literature package in the oven. Gas orifice spuds are stamped with a number, marked with 1 or 2 color dots, and have a groove in the hex area. Replace the Natural gas orifice spud with the correct Propane gas orifice spud. A NG NG B D E LP LP C Side view after A. Plastic cover B. Gas pressure regulator cap with solid end facing out C. Gas pressure regulator cap with hollow end facing out D. Washer E. Gas pressure regulator cap 5. Turn over the gas pressure regulator cap and reinstall on regulator so that the hollow end faces out and the marking "LP" is facing the direction shown in the above drawing. 6. Replace plastic cover over gas pressure regulator cap. To Convert Surface Burners (Natural Gas to Propane Gas) 1. Remove burner cap. 2. Remove the burner base. B C D A A. Igniter electrode B. Burner cap C. Gas tube opening D. Burner base 3. Apply masking tape to the end of a 9/32" (7 mm) nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas orifice spud aside. AB D C A. Igniter electrode B. Orifice spud C. Orifice spud holder D. Screws A. Propane groove Refer to the following chart for correct Propane gas orifice spud ratings and to spud holder card for proper placement. Propane Gas Orifice Spud Chart for Surface Burners Burner Rating/Type 13,500 BTU 4,500 BTU 13,500 BTU 7,500 BTU 10,000 BTU Color Size (mm) 1.55 0.61 1.06 Red/Blue 0.80 0.92 ID Number L155 L61 L106 L80 L92 Placement LF LR RF RR CTR NOTE: Refer to the model/serial/rating plate located on the oven frame behind the top right-hand side of the oven door for proper sizing of spuds for each burner location. 5. Place Natural gas orifice spuds in the orifice spud bag. IMPORTANT: Keep the Natural gas orifice spuds in case of reinstallation with Natural gas. 6. Replace the burner base. 7. Replace burner cap. 8. Repeat steps 1 to 7 for the remaining burners. To Convert Oven Bake Burner (Natural Gas to Propane Gas) 1. Remove the oven racks and the oven door. See the "Oven Door" section. 2. Remove two screws and washers at the rear of the oven bottom. 3. Lift the rear of the oven bottom up and back until the front of the panel is away from the front frame. Remove from oven and set it aside on a covered surface. A B A. Screws B. Oven bottom 17