Whirlpool WFE321LWB Installation Instructions - Page 13

To Replace: 1. Lift up the back of the storage drawer and place it inside the range in its fully forward position. 2. Lift up the front of the storage drawer to a level position. 3. Slowly push the storage drawer into the range until the drawer side rails engage with the gap in the drawer glides. A A. Engage drawer glide. 4. Once the storage drawer is fully engaged on both sides, slide the drawer back into the closed position. 5. NOTE: When you are removing and replacing the storage drawer, a slight push may be needed to move the drawer stop notch past the drawer glides. Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. 3. Dispose of/recycle all packaging materials. 4. Check that the range is level. See "Level Range." 5. Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, read the "Range Care" section of the Use and Care Guide. 6. Read "Range Use" in the range Use and Care Guide. 7. Plug power cord into appropriate outlet. Turn power on. 8. Turn on surface burners and oven. See the Use and Care Guide for specific instruction on range operation. If range does not operate, check the following: ■ Household fuse is intact and tight; or circuit breaker has not tripped. ■ Range is plugged into an outlet. ■ Electrical supply is connected. ■ See "Troubleshooting" in the Use and Care Guide. When the range has been on for 5 minutes, check for heat. If range is cold, turn off the range and contact a qualified technician. 13