Whirlpool WGD6600VW Use and Care Guide - Page 12
Level Dryer, Reverse Door Swing
UPC - 883049141237
View all Whirlpool WGD6600VW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Level Dryer Check the levelness of the dryer by first placing a level on the top of the dryer near the console. 3. Loosen the top screw from each of the 2 hinges in Step 2. A B Then, by placing a level in the crease on the side of the dryer between the top of the dryer and the dryer cabinet, check the levelness from front to back. If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs up or down and check again for levelness. A B A. Loosen these screws. B. Remove these screws. 4. Remove the dryer door and the hinges by lifting upward on the door. Lay the door on a flat, protected surface, with the inside of the door facing up. Remove remaining 2 loose screws from dryer front panel. 5. Remove the 4 plastic plugs located outside the dryer door opening. Reverse Door Swing You can change your door swing from a right-side opening to a leftside opening, if desired. 1. Place a towel or soft cloth on top of the dryer or work space to avoid damaging the surface. Remove the door assembly 1. Open the dryer door. 2. Remove the bottom screw from each of the 2 hinges that attach the dryer door to the front panel of the dryer. 6. Install 4 plastic plugs into screw holes in the dryer left where the hinges were removed in Step 4. 12
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52