Whirlpool WOCA7EC0H Installation Instructions - Page 5

Replace Oven Door 1. Using two hands, grasp side edges of door at the midpoint. Face the oven cavity. 2. Locate the slots on each side of the oven cavity for the door hinge locks. 6. Close the oven door. 7. When the hinges are properly installed and the door closed, there should be an even gap between the door and the control panel. If one side of the oven door is hanging lower than the other, the hinge on that side is not properly installed. Repeat the steps to remove then replace the oven door. See the "Remove Oven Door" and "Replace Oven Door" sections Positioning Oven Feet The oven feet need to be installed to allow a microwave/oven combination to be installed in a recommended cutout height of 421/2" (107.9 cm). NOTE: Do not remove the spacers. A A. Slot in the oven cavity for door hinge lock 3. At a 45° angle, align door hinges with slots in the lower front of the oven cavity. Slowly insert door, making sure you maintain the 45° angle. You will know the door is engaged in the slot when you feel a slight drop. 4. Lower the oven door to the fully open position. If the oven door does not open to a full 90 degrees, repeat steps 1 through 3. 5. Locate the oven door hinge locks in the corners of the oven door, and rotate the hinge locks toward the oven cavity to the locked position. See Step 3 (illustration A) in the "Remove Oven Door(s)" section for proper locked position. A A. Spacers 1. Using 2 or more people, place the oven on its back on a covered surface. 5