Whirlpool WOES5027LW Dimension Guide - Page 4

DIMENSION GUIDE Single Ovens Undercounter - without cooktop installed above A B A C D E F G G H I H FRONT VIEW 27" (68.6 cm) models A. Recommended junction box location B. 3/4" (1.9 cm) top cleat* C. 271⁄4" (69.2 cm) minimum width of flush inset cutout D. 257⁄8" (65.7 cm) minimum width of opening E. 291⁄4" (74.3 cm) minimum height of flush inset cutout F. 281⁄2" (72.4 cm) recommended cutout height G. 11/16" (1.7 cm) side cleat* H. 1/4" (0.64 cm) spacer the entire depth of the cabinet* I. 45⁄8" (11.7 cm) bottom of cutout to floor *Cleats and spacers must be recessed 13⁄8" (3.5 cm) from the front of the cabinet. A A B C D D TOP VIEW 27" (68.6 cm) models A. 2" (5.1 cm) spacer the entire depth of the cutout* B. 25" (63.5 cm) depth of cutout C. 13⁄8" (3.5 cm) recess from front of cabinet D. 11/16" (1.7 cm) side cleat* *Cleats and spacers must be recessed 13⁄8" (3.5 cm) from the front of the cabinet. 4 of 18 Cutout Dimensions For Ovens Installed Under Cooktop IMPORTANT: Observe all governing codes and ordinances. Cooktop must be approved for use over an oven. See cooktop Installation Instructions for cutout dimensions. Center the cooktop cutout over oven cutout. Ovens approved for this type of installation have an approval label located on the top of the oven. To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C). Approved Built-In Oven and Electric Coil/Radiant/Induction Cooktop Combinations or without Cooktop Installed above Oven A B C I D E C F G H A. 24" (61 cm) cabinet depth B. 25" (63.5 cm) countertop depth C. Recommended oven and cooktop junction box locations D. Allow 5/8" (1.6 cm) for oven trim to overlap on each side. E. 273⁄4" (70.5 cm) minimum cutout height F. 36" (91.4 cm) from cabinet base to countertop G. 45⁄8" (11.7 cm) maximum from cabinet base with feet installed. If dimension "F" is greater than 36" (91.4 cm), dimension "G" can be increased the same difference for induction combinations. H. 251⁄2" (64.8 cm) minimum oven cutout dimension I. 313⁄8" (79.7 cm) from top of countertop to bottom of cutout For the approved model number combinations, refer to the undercounter label located on top of the oven chassis and on the bottom of the cooktop burner box. NOTE: For undercounter installation, it is recommended that the junction boxes for oven and cooktop be located in the adjacent right or left cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the upper rear right or left corner of the side wall surface to pass the appliance cable through to the junction box.