Whirlpool WRF954CIHV Owners Manual - Page 30
Shelves with under-shelf lighting on some models
View all Whirlpool WRF954CIHV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
3. Apply pressure to the top of the shelf to ensure the shelf is properly seated on the shelf mounts. 3. Push the clip up from the bottom with your finger. 4. After both clips have been disengaged, carefully remove the pull-out platter toward the front of the refrigerator. To remove and replace shelves: 1. Make sure adjustable shelf mounts are in the lower position before removing shelves. Doors will need to be open at a 90˚ angle. If open wider, it will make it harder to remove the shelves. 2. Remove the middle shelf or top shelf by lifting it up and out of the shelf supports. Then pull the shelf forward and tilt down to a vertical position. Turn the shelf at an angle and pull out of the refrigerator. NOTES: ■■ You will need to remove middle shelf first before removing the top shelf. ■■ Infinity-slide glass shelves should be pushed back in. When tilted up, make sure glass does not slide to front. 3. Remove the bottom shelf by lifting it up and out of the shelf supports. Then pull the shelf forward and tilt up to a vertical position. Turn the shelf at an angle and pull out of the refrigerator. 4. Replace the middle and top shelves by putting the shelf in the refrigerator at an angle with the shelf front down. Lift the front of the shelf up and in until rear shelf drops into the shelf supports. Lower the front of the shelf and make sure that the shelf is in position. 5. Replace the bottom shelf by putting the shelf in the refrigerator at an angle with the shelf up. Lift the front of the shelf down and in until rear shelf drops into the shelf supports. Lower the front of the shelf and make sure that the shelf is in position. Shelves with under-shelf lighting (on some models) By moving LED lighting to a new spot under the shelves, this leading-edge technology improves interior refrigerator lighting and aids in locating storage items. Platter Pocket Removal To remove and replace pull-out platter: NOTE: Refrigerator doors will need to be removed to remove platter pocket. See the "Remove and Replace Refrigerator Doors" section for more information. 1. Pull the pull-out platter to the fully open position or when it stops. 2. Locate the pull-out platter retention clips on both sides. These are in the side under the pull-out platter. Crisper Drawers To remove and replace the drawers: 1. Grasp the handle at the bottom of the drawer and slide the drawer straight out to the stop. Lift the drawer off the bottom guide. 2. Replace the drawer by placing it on the bottom drawer guide and pushing it past the drawer stop into position. To remove the crispers cover (can remove only if pull-out platter is removed first): 1. Remove the pull-out platter first. 2. Holding the glass insert firmly with one hand, press up in center of glass insert until it rises above the plastic frame. Gently slide the glass insert forward to remove. To replace crisper(s) cover: 1. Remove the crisper pan, pull-out platter, and crisper glass before removing the crisper. 2. Fit back of cover frame into supports on side walls of the refrigerator and lower the front of the cover frame into place. 3. Slide rear of glass insert into cover frame and lower front into place. 30