Whirlpool WTW6700TU Use and Care Guide - Page 17

Deep Clean This option provides enhanced cleaning action for tough stains. The Heavy Duty cycle automatically includes Deep Clean. Choosing Deep Clean will add approximately 5 minutes to a cycle. Deep Clean should be started on a dry load only and cannot be selected after the tub has started filling with water. Deep Clean may be selected as an option with other cycles. See table for details. Cycle Deep Clean (Adds time to the wash cycle) Whitest Whites Option Heavy Duty Default Bulky Items Not available Sheets/Towels Not available Normal Option Casual/Perm Press Option Colors/Darks Option Quick Wash Option Wool Not available Delicate/Handwash Option Soak Not available Rinse & Spin Not available Drain & Spin Not available Clean Washer Not available Extra Rinse An extra rinse can be used to aid in the removal of detergent or bleach residue from garments. This option provides an additional rinse with the same water temperature as the first rinse. This is the default rinse setting for the Whitest Whites cycle. Cycle Signal Volume The Cycle Signal produces an audible sound when the wash cycle is finished. This signal is helpful when you are removing items from the washer as soon as it stops. Select Loud, Soft or Off. Fabric Softener Fabric Softener option must be selected if liquid fabric softener is added to the fabric softener dispenser. This option flushes the dispenser at the correct time in a deep water rinse for optimal distribution. Operating Controls Power Press POWER to turn the washer on or off. Start Press START to start your washer after a cycle has been selected. Be sure all desired Modifiers and Options have been selected. The lid must be closed for the washer to start. Pause/Cancel Press PAUSE/CANCEL once to pause or stop the washer at any time. Press PAUSE/CANCEL once to unlock the lid and add a garment. Press START to complete the cycle from where it was stopped. Press PAUSE/CANCEL twice to stop the wash cycle. The washer will then drain and turn off. Lid Lock When the Lid Lock status light glows, the washer lid is locked. NOTE: You must wait until the Lid Lock Light turns off before the lid can be opened. Normal Sounds Your new washer may make sounds your old one didn't. Because the sounds might be unfamiliar, you may be concerned about them. These sounds are normal. During washing If you select the Deep Clean option, you will hear a spin/spray noise at the start of the cycle. During drain If water is drained quickly from your washer (depending on your installation), you may hear air being pulled through the pump during the end of draining. During wash and spin This washer does not have a transmission. The motor provides direct drive for agitation and spin. You will hear sounds that are different from those of a conventional washer. 17