Whirlpool WTW8200YW Use & Care Guide - Page 10

7. Select cycle Turn cycle knob to choose your wash cycle. Estimated Time Remaining will light up with a cycle time. You may notice time adjusting during the cycle. This is normal. If you do not want to begin a cycle immediately, you may choose the DELAY WASH option. To choose a delay time: 1. Press DELAY WASH button to select desired delay time. 2. Press START/PAUSE to set the delay. The delay countdown has started when the START/PAUSE light stops blinking. To cancel delaying a cycle: 1. Press START/PAUSE again to begin a wash cycle immediately. IMPORTANT: When delaying a cycle, use liquid HE detergent only in the dispenser. Powdered detergents may absorb moisture from a previous cycle and clump before the wash cycle begins. 8. Select cycle modifiers, if desired Wash Temp Suggested Fabrics Hot Some cold water is added to save energy. This will be cooler than your hot water heater setting. Whites and pastels Durable garments Heavy soils Warm Some cold water will be added, so this may be cooler than what your previous washer provided. Bright colors Moderate to light soils Cool Warm water is added to assist in soil removal and to help dissolve detergents. Cold Warm water may be added to assist in soil removal and to help dissolve detergents. Dark colors that bleed or fade Light soils Dark colors that bleed or fade Light soils 9. Select cycle options Select any other cycle options you may wish to add, if not previously set. Some cycles will automatically add certain options such as Extra Rinse. These may be turned off, if desired. NOTE: Not all options are available with all cycles. 10. Press START/PAUSE to begin wash cycle Once you select a cycle, the default settings for that cycle will be lit. Press the cycle modifiers buttons to change the Soil Level, Spin Speed, and Wash Temp, if desired. Not all settings are available with all cycles. NOTE: Always read and follow fabric care labels instructions to avoid damage to your garments. 10 Press the START/PAUSE button to start the wash cycle. When the cycle has finished, the DONE indicator will light and the end of cycle signal will sound (if set). Promptly remove garments when cycle is done to avoid odor, reduce wrinkling, and rusting of metal hooks, zippers, and snaps. Unlocking the lid to add garments If you need to open the lid to add 1 or 2 missed garments: Press START/PAUSE; the lid will unlock once the washer movement has stopped. This may take several minutes if the load was spinning at high speed. Then close lid and press START/PAUSE again to restart the cycle. If lid is left open for more than 10 minutes the water will pump out.