Xerox 3130 Service Manual - Page 31

TROUBLESHOOTING 4.2.11 Ghost (3) • Description White ghost occurs in the black image printing at 32mm intervals. DDiiggiittaall PPrriinntteerr DDiiggiittaall PPrriinntteerr DDiiggiittaall PPrriinntteerr 37mm Check and Cause 1. The life of the developer may be expired. Solution 1. Occur in the developer cartridge, replace the developer and try to print out. 2. The abnormal voltage and bad contact of the terminal of the supply roller 2. Check the approved voltage of the supply roller and contact of the terminal and adjust if necessary. 4.2.12 Ghost (4) • Description Ghost occurs at 47 mm intervals. DDiiggiittaall PPrriinntteerr DDiiggiittaall PPrriinntteerr DDiiggiittaall PPrriinntteerr 47mm Check and Cause The temperature of the fuser is maintained high. Solution 1. Disassemble the fuser and remove the contaminated toner particles on the roller and clean the foreign matter between Thermistor and Heat roller. ( Caution : can be deformed) 4.2.13 Satins on the Face of Page • Description The background on the face of the printed page is stained. Digital Printer Digital Printer Digital Printer Digital Printer Digital Printer Check and Cause 1. Toner leakage due to improperly sealed developer. Solution 1. Replace the developer cartridge. 2. If the transfer roller is contaminated, satins on the face of page will occur. 2. If the transfer roller is contaminated, run PC Cleaning Mode Print 2 or 3 times. And perform Self-Test 2 or 3 times to remove contamination. Service Manual 4-11