Xerox 6180N Installation Preparation Document - Page 1
Xerox 6180N - Phaser Color Laser Printer Manual
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Preparation Document (for physical installation of the product only) Xerox DocuTech 6155/6180 Customer Support The Xerox Customer Support Center is available to provide general information, answer questions, and take service calls. You can reach the Customer Support Center at the following toll-free phone number: United States 1-800-821-2797 Your Xerox Analyst will provide fee-based training upon request. Space Requirements / Service Envelope The components of the DocuTech 6180 system are: • DocuSP Controller (monitor, keyboard, mouse) • Printer D DocuTech 61xx E P T H WIDTH Representation only. Note: The 6155 and 6180 are available with and without a stand to support the controller. If a stand (098S04797) is ordered, it will be positioned to the left of the printer, within the service space envelope. If no stand is ordered, the controller will be placed on the floor to the left of the printer in the service space envelope. Note: The dimensions shown below provide the overall service space required, including the space to the nearest obstruction. The dimensions are in inches and are absolute minimums Configuration 6155, 6180 with interposer and finisher With stand Width Depth 243.0" 114.0" Without stand Width Depth 240.0" 114.0" Electrical Requirements - DocuTech 6155 / 6180 For the printer one (1) electrical service option is available - 2-phase, dual power cord. MultiSource 2-phase, dual power cord configuration Voltage 208/240(4 wire) 208/240 (4 wire) Amperage 50 30 Cycles 60 Hz 60 Hz Receptacle Xerox Part No. 600S3779 600S3277 Receptacle NEMA Part No. 14-50R 14-30R Receptacle Diagram Electrical Requirements Digital Front End (DFE) Controller Platform: Line Options: Dedicated Voltage 110 Amperage 15 Cycles 15 amp Receptacle Xerox Part No. 20 amp Receptacle Xerox Part No. Receptacle NEMA Part No. 60 Hz 600S3704 600S3703 5 - 20R or 5 - 15R Receptacle Diagram or • All controller configurations require a 110VAC, 15 Amp grounded receptacle for the outlet strip that provides receptacles for the controller and its peripheral devices (monitor, modem, CDROM drive, and tape drive) • Adapters that eliminate the ground connection to the outlet can not be used. • Xerox provides 15 feet of cabling with Teflon coating (Plenum rated), to connect the controller to the Processor/Finisher. Environmental Requirements Recommended Min. Max. Temperature 68o F - 76oF (20o C-24o C) 50 o F (10o C) 85o F* (29o C) Humidity 45% +/-10% 30% RH 60% RH Heat Emission - with Binder On (with processor, interposer, finisher and binder) - 14,185 22,165 BTU/Hr BTU/Hr (with vent kit) (Running) Heat Emission - with Binder Off (with processor, interposer, finisher and binder) - 13,609 21,265 BTU/Hr BTU/Hr (with vent kit) (Running) Altitude (above Up to 6,000 ft. - sea level) 9,000 ft. * The system will inhibit software problems and shut down above 90 o F Power Cord Kit Number Power Cord Length 98K59581 15 feet 15 feet Please ensure electrical, space, and supplies are available prior to equipment delivery. 701P43858 June 2005