Xerox 6180N Installation Preparation Document - Page 2

Installation Preparation Document (for physical installation of the product only) Xerox DocuTech 6155/6180 Installation Considerations • There should be a minimum of 78 inches (1,981mm) clearance from the floor to the nearest overhead obstruction. • Dedicated power outlets are required. Ensure each power cord has a separate circuit that cannot be shared with other devices. • Electrical outlet must be located within 13.1 feet of the equipment. • Mobility Assist Device - The optional mobility assist device reduces the installation clearance required to 30 inches (760mm) at the processor end of the printer and 15 inches (380 mm) at the finisher end. • For proper operation, the printer must be perfectly level. The floor must be level within 2 degrees in any direction. On floors less than 2 degrees out of level, installation personnel install a leveling kit to level the machine. • If the floor is more than 2 degrees out of level, this condition cannot be corrected by the leveling kit. Another suitable location must be found for the printer to be installed properly. • A minimum 50-inch clearance of exclusive operator area must be maintained in front of each component. This space cannot be shared. • A minimum of 36 inches of clearance in the back of each component for general service clearance. Engineers (IEEE) 802.3 standard. (The physical form of this connector is RJ45 and must be correctly wired.) • The DocuSP controller supports TCP-IP, SPX/IPX, and EtherTalk Link Access Protocol (ELAP) protocols if the proper gateways are installed on the controller. • The DocuSP controller does not provide Novell Server network services. To use the SPX/IPX protocol, a Novell server installed on the network is required. • A Xerox Token Ring solution is available for the 61XX family. When Token Ring is installed, it becomes a Token Ring only connectivity solution. The NetWare gateway and AppleTalk gateway will not function, and the built in Ethernet bge0 twisted pair interfaces are disabled. (Gigabit Ethernet is supported - some customers have asked for this option.) Telephone Requirements A voice telephone line is required where the DocuTech 6155 or 6180 is installed. Voice line will be used when the operator, administrator, or Xerox Service Personnel is asked to read the screen information from the DocuSP controller dialogs to Xerox Customer Support or Technical Support Center Personnel. Physical requirements • The DocuSP Controller Monitor and Keyboard are designed to be positioned on top of the DocuTech 61XX printer. The controller platform is designed to either be mounted in a stand to the left of the printer, or to be positioned on the floor to the left of the printer • Warning: Due to safety requirements, under no circumstances should the user interface be visually separated from the printer module. All system installations must enable mobility of the user interface to within 30" (760 mm) of the printer for service and customer maintenance actions. Operating Supplies Position / Performance at Maturity UM* C 14 a l 12 Al v s 10 e rP 8 ae gr 6 e M o n1 t h Optimum Range 1M 2M 3M 4M 5M 6M Reorder No. Impressions / Unit Dry Ink 6R206 220,000 / Carton 1 Developer 5R161 600,000 / Carton Fuser Agent 8R2955 250,000 / Bottle Stitcher Wire 8R1174 32,000 / Reel Binder Tape - Black 8R2928 425 Binds / Reel Binder Tape - White 8R3601 425 Binds / Reel Binder Tape - Gray 8R3602 425 Binds / Reel Binder Tape - Blue 8R3603 425 Binds / Reel Binder Tape - Brown 8R3604 425 Binds / Reel Binder Tape - Red 8R3824 425 Binds / Reel 1 Expected dry ink yield is based on 6% coverage on letter paper. Actual usage will vary widely with % area coverage, density settings, and paper size used. The US supplies Marketing Center, 1.800.822.2200 is available for ordering all Xerox supplies, including paper and throughput material. Network Requirements • The Ethernet interface on the DocuSP controller is a 10/100MB/sec twisted pair standard (10BaseT). • The Ethernet connection to the DocuSP controller must be compatible with the Institute of Electrical and Electronics *Unscheduled Maintenance Average Monthly Print Volume (M = Million) Note: • This product is targeted for the 1.8 to 6.0 million impressions per month market segment. Usage above this range may result in a higher service frequency. • Variables other than monthly print volume affect average number of service calls. Please contact your sales representative or Customer Service Engineer for more information. Please ensure electrical, space, and supplies are available prior to equipment delivery. 701P43858 June 2005