Yamaha 140 Owner's Manual - Page 35

Keyboard Stand Assembly Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor- dance with the sequence given below. • Assembly should be carried out by at least two persons. • Assemble the stand on the flat floor surface. • Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Use of incorrect screws can cause damage or malfunction of the product. • Be sure to tighten up all screws upon completing assembly of each unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver ready Remove all parts from the package and make sure you have all of the items. A D E B C Bundled pedal cord inside AC Power cord (YDP-160) AC Power adaptor (YDP-140) Assembly Parts 6 × 20 mm long screws ×4 1 4 × 20 mm tapping screws ×4 4 6 × 16 mm short screws ×4 2 Cord holders × 2 4 × 12 mm thin screws ×2 3 1. Attach (finger-tighten) C to D and E. 1-1 Untie and straighten out the bundled pedal cord. Don't discard the vinyl tie. You will need it later in step 6. 1-2 Align D and E with each end of C. 1-3 Attach D and E to C by finger-tightening the long screws 1 (6 × 20mm). E 1-2 C 1-3 D 1-1 L Headphone hanger set (YDP-160 only) 4 × 10 mm thin screws ×2 5 Headphone hanger 33 YDP-160/140 Owner's Manual 35