Yamaha 24N DME64N/24N V1 Owners Manual - Page 16

The Controls and Connectors Front Panel The Controls and Connectors Front Panel DME64N 1 DME24N 1 ) 9 ^ & º¡ !@#$% SCENE HOME UTILITY LEVEL MUTE * CANCEL ( ENTER 2 4 5 3 6 ™ £ ) ^ 9 ! SCENE @ HOME #$ UTILITY LEVEL % MUTE * CANCEL ( ENTER & º¡ ™ £ 2 3 4 7 5 8 6 7 8 1 [USB] Connector A computer can be connected here when it is necessary to program or control the device. When a USB connection is to be used, the USB-MIDI driver must be installed on the computer. Refer to the DME Designer Installation Guide for installation instructions. 2 [EXT. CLOCK] Indicator When a clock signal from an external device is selected, the indicator will light green. If the clock signal is not appropriate the indicator will flash red. The indicator will go out when the internal word clock is selected. 3 [96kHz] [88.2kHz] [48kHz] [44.1kHz] Indicator Normally, the indicator corresponding to the current word clock frequency will light green. If a problem with the master clock is detected all of these indicators will flash red. 2 seconds after a problem is detected with an external master clock the internal clock will temporarily be selected. When this happens the indicator corresponding to the frequency of the internal clock will light green, and all other indicators will continue to flash red. 4 [NETWORK] Indicator Lights while data communication is occurring via the [USB], [NETWORK], or [CASCADE] connector. Received data causes the indicator to light in green, while transmitted data causes the indicator to light in orange. If a problem occurs the indicator will light in red. 16 DME64N/24N Owner's Manual