Yamaha 24N DME64N/24N V1 Owners Manual - Page 23
I/O Card Installation Procedure
View all Yamaha 24N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Preparation I/O Card Installation I/O Card Installation Procedure 1. Make sure that the DME64N/24N power is OFF. If the power is on, turn it off. 2. Loosen the two card slot screws and remove the slot cover, as shown in the diagram. NOTE The slot cover and screws will need to be re-attached if the I/O card is later removed from the slot, so keep them in a safe place. 3. Slide the I/O card into the slots in the guide rails, as shown in the diagram, and push the card into the slot. Be sure to push the card all the way back into the slot so that the card contacts make proper contact with the slot connector. Guide Rail 4. Secure the card with the attached screws. Be sure to tighten the screws securely. If the screws are left loose proper contact may be lost and malfunction of damage may result. CAUTION DME64N/24N Owner's Manual 23