Yamaha 860 Owner's Manual - Page 66
minus screwdriver to rotate the selector dial so that the cor, selector for 110V, 127V
View all Yamaha 860 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
6 7 Cord holder q A voltage selector is provided in some areas. 240 220 110 q Use the vinyl tie that was removed from the bundled pedal cord in step C to tie up any slack in the pedal cord. 127 N Connect the pedal cord. Pass the pedal cord through the two cord holders on the side panel. Plug the free end of the cord into the PEDAL connector on the rear of the main unit. M Voltage Selector Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected connect the AC power cord. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area. 66 CLP-880/860/840/820/820S