Yamaha Audiogram3 Owners Manual - Page 9
Powering Up the System - drivers
View all Yamaha Audiogram3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Quick Guide 3 Step Powering Up the System To prevent loud pops and noises, turn on the power to your sound gear starting with the sources (instruments, CD players, etc.) and ending with the audio system (monitor speakers). 1 Turn on the instruments and microphones. 2 If you are using a condenser microphone for the channel 1, turn on the PHANTOM +48V switch. Observe the following precautions when turning on phantom power. CAUTION • Make sure that the PHANTOM +48V switch is off when phantom power is not needed. • When turning the switch on, be sure that only a condenser microphone is connected to the MIC/INST input jack. Other devices may be damaged if connected to phantom power. This precaution does not apply to balanced dynamic microphones or instruments with the phone jack, however, as these will not be affected by phantom power. • To prevent damage to speakers, be sure to turn off audio system (monitor speakers) before turning this switch on or off. We also recommend that you set the OUT LEVEL control to the minimum position before operating this switch to avoid the risk of loud noises that could cause hearing loss or device damage. 3 Connect the AUDIOGRAM interface to your computer using the supplied USB cable. The POWER indicator will light to indicate that power is being applied to the AUDIOGRAM interface. USB Connection Precautions Be sure to observe the following points when connecting to the computer's USB interface. Failure to observe these rules can result in computer freezes/hang-ups and possibly data loss or corruption. If the instrument or computer does hang up, restart the application or computer. CAUTION • Be sure to wake the computer from sleep/suspended/standby mode before making a connection to the computer's USB connector. • Always quit all applications running on the computer before connecting or disconnecting the USB cable. • Wait at least 6 seconds between connecting or disconnecting the USB cable. CAUTION NOTE When connecting or disconnecting the USB cable be sure to turn the OUT LEVEL control all the way down. The first time you connect to the computer's USB connector, or change the connection to a different USB port, a driver installation display may appear. If this occurs, wait until the installation is complete before proceeding. 4 Turn the power to the audio system (monitor speakers). AUDIOGRAM 3 Owner's Manual 9