Yamaha BD-S1065 Owners Manual - Page 36

Settings Note - When "Secondary Audio" is set to "On", PCM is automatically selected as the audio output mode. When you selected "Digital Output" Bitstream*: PCM: - Select this when connecting to SURROUND equipment with a built-in decoder for DOLBY DIGITAL, etc. - Setting to Bitstream will output each audio signal by Bitstream. - Select this when connecting to 2 channel stereo audio equipment. - Setting to PCM will output by converting each audio signal into PCM 2 channel audio signal. Note - See page 38 for information on the audio output formats. Dynamic Range Control This lets you adjust the range between the loudest and softest sounds (dynamic range) for playback at average volume. Use this when it is hard to hear dialog. Normal: The same audio output range is played as the original recorded audio output range. Shift: When Dolby Digital audio is played back, the dynamic range of the audio is adjusted so that the dialog portion can be heard easily. (If the audio sounds abnormal, set to "Normal".) Auto*: When you play back audio in the Dolby TrueHD format, the dynamic range is automatically adjusted. * Lower the audio volume before setting. If you do not do so, the speakers may emit a loud sound or excessive output may be applied to the speakers. ■ Speaker Settings This sets size, distance, and volume levels for individual speakers when you connect using AUDIO OUT (8ch discrete) jacks. 1 Press SETUP to display the Setup Menu screen. 2 Press / / / to select "Settings", then press ENTER. 3 Press / to select "Speaker Settings", then press ENTER. 4 Press / to select "Yes", then press ENTER. - Select "No" to cancel without configuring the Speaker Settings. Audio output can be set according to the connected amplifler and speaker systems. (When 7.1ch output terminal is not used, it is not necessary to set it.) Do you want to adjust the speaker settings? Yes No 5 Press / / / to select a speaker you want to configure, then press ENTER. L (Front Left), C (Center), R (Front Right), RS (Surround Right), RB (Surround Back Right), LB (Surround Back Left), LS (Surround Left), SW (Subwoofer) Set the speaker size, distance from listening point, and the sound level to each speakers. Select speaker. 0dB SW 12ft/+1dB L 12ft/ 0dB C 12ft/ 0dB R LS 6ft/ 0dB LB 6ft/ 0dB Test Start RB 6ft/ 0dB Finish RS 6ft/ 0dB 6 Press / to select "Size", "Distance", and "Level", then press / to set the value for the selected item. Size: Distance: Level: You can set the sizes from "Small", "Large*", and "No". You can set the distances from "0.3m (1 ft)" "3.0m (10 ft)*" - "9m (29 ft)". You can set the volume levels from "-12 dB" "0 dB*". Notes - When "SW" is set to "No", the speakers cannot be set to "Small". Set the speaker size, distance from listening point, and the sound level to each speakers. 0dB SW 12ft/ 0dB L 12ft/ 0dB C 12ft/ 0dB R LS 6ft/ 0dB LB 6ft/ 0dB Size Distance Small 12ft RB 6ft/ 0dB Level 0dB RS 6ft/ 0dB - To set the other items, repeat step 6. - To set the other speakers, repeat step 5 - 6. 7 Press to select "Test Start", then press ENTER. The test tone is output from each speaker to help you judge the volume levels. 8 Press to select "Test Tone Stop", then press ENTER. The test tone stops. 9 Press to select "Finish", then press ENTER. 32 En