Yamaha CDC-775 Owner's Manual - Page 23

English Display information during programming PROG 12345 6 7 8 9 10 Œ   PROG 12345 6 7 8 9 10 Ž Œ Shows the side of the tape and the program number for the track to be programmed next.  Shows the selected disc and track number. Ž Shows the total remaining time on the side of the tape.  Programmed track numbers light up and programmable track numbers among the unprogrammed ones blink. * If "A-1" does not appear in the display after the PROG button is pressed, press the TIME display mode-select button. * If, during programming, the TIME display mode-select button is pressed, the program number display can be changed to display the total remaining time on the side of the tape. To return to the previous display, press the TIME display modeselect button once again. s Random sequential tape programming The unit will automatically program tracks on a disc in random sequential order for recording to tape. 2 4 SYNCHRO PEAK DIMMER TIME OPEN/ CLOSE REPEAT RANDOM TAPE CLEAR PROG 1 2 3 4 5 6 7 8 9 0 +10 FILE EDIT FILE MODE INDEX CAPS DISC SKIP/ CHARACTER DISC MODE TEXT MODE TEXT SRCH ENTER DISC SCAN SKIP/SEARCH OUTPUT LEVEL STOP PAUSE PLAY 3, 4 1 Follow steps 1 - 4 on page 21. 2 RANDOM The unit will automatically program tracks for side A and side B separately considering the tape's total time. * The programmed track numbers and the total number of tracks for side A and B are displayed for a short time. 3 Start recording on the tape deck and press the PLAY button on this unit's remote control transmitter at the same time. 4 The unit will pause at the end of side A of the tape. Turn the tape over to side B. Resume recording and, at the same time, press the PLAY or PAUSE button on this unit's remote control transmitter. Notes q Because the programmed data changes every time the RANDOM button is pressed, the amount of time remaining at the end of the tape also changes accordingly. q It is recommended that you use a tape that is slightly longer in length than the CD you are recording, because the programmed tracks on a CD may not fit properly into the time allowed on each half of the tape. q CD synchronized recording function can be used if your tape deck is compatible with it. In this case, in steps 3 and 4, press the SYNCHRO button and then press the PLAY button on this unit's remote control transmitter. Recording automatically begins. (For details, refer to page 20.) Display information during programming Ž PROG 135 7 Œ  Œ Shows the number of programmed tracks for each side in turn just after the automatic programming is finished, and then it is replaced by the number of the first programmed track for side A.  Shows the total time of programmed tracks for each side. Ž Shows the programmed track numbers for each side. 23