Yamaha CDX-593MKII Owner's Manual - Page 5

English CDX-393MKII LINE OUT 1 DIGITAL AUDIO OUT OPTICAL CDX-393MKII To AC outlet 1 Connection cord (included) 2 Optical fiber cable (not included) Amplifier CD OPTICAL DIGITAL IN To connect this unit to your amplifier, choose one of the following procedures: 1 When the LINE OUT (analog) terminals of this unit are used • Be sure that the left ("L") and right ("R") LINE OUT terminals are connected to the corresponding (left and right) terminals of the amplifier or other component. • Connect the "LINE OUT" terminals to the "CD" (or "AUX") terminals of the amplifier. If the amplifier does not have such terminals, use the "TAPE PB" terminals. For additional details concerning these connections, refer to the operation instructions for the amplifier being used. • The LINE OUT terminals of this unit are numbered 1. When connecting this unit with a YAMAHA amplifier or receiver whose terminals on the rear panel are numbered as 1, 2, 3, etc., connect the LINE OUT terminals of this unit to the input terminals numbered 1 on the rear of the amplifier or receiver. 2 When the DIGITAL OUT (OPTICAL) terminal of this unit is used • Before using this terminal, remove the terminal's cover. • Make the connection from this terminal to the optical input terminal of an amplifier by using a commercially available optical fiber cable. * Use an optical fiber cable that conforms to EIAJ standards. Other cables might not function correctly. • Be sure to replace the terminal's cover when this terminal is not being used, in order to protect the terminal from dust. • This terminal can also be connected to the optical input terminal of a digital audio tape deck (DAT) etc. to record CD onto a tape directly. CDX-593 and CDX-493 • The signal output level to an amplifier can be adjusted by using the OUTPUT LEVEL button. 3 CDX-593 When the DIGITAL OUT (COAXIAL) terminal of this unit is used • Make the connection from this terminal to the digital input terminal of an amplifier by using a connection cord. • The signal output level to an amplifier can be adjusted by using the OUTPUT LEVEL button. 5