Yamaha CLP-220 Owner's Manual - Page 34
Keyboard Stand Assembly
View all Yamaha CLP-220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
ENGLISH Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Do not use any other screws. Use of incorrect screws can cause damage or malfunction of the product. • Be sure to tighten up all screws upon completing assembly of each unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver ready Remove all parts from the package and make sure you have all of the items. A D E B C Bundled pedal cord inside AC power cord Assembly Parts 6 × 20 mm long screws ×4 1 4 × 20 mm tapping screws ×4 4 6 × 16 mm short screws ×4 2 Cord holders × 2 4 × 12 mm thin screws ×2 3 Side panel protection (cardboard) pads × 2 1. Attach (finger-tighten) C to D and E. 1-1 Untie and straighten out the bundled pedal cord. Don't discard the vinyl tie. You will need it later in step 6. 1-2 Align D and E with each end of C. 1-3 Attach D and E to C by finger-tightening the long screws 1 (6 × 20mm). E 1-2 D C 1-3 1-1 2. Attach B. Depending on the model of Clavinova you purchased, the surface color of one side of B may be different from the other side. In this case, position B so that the side of the surface color similar to D and E faces the player. 2-1 Place the lower side of B on each foot of D and E, then attach the upper side to D and E. 2-2 Attach the top of B to D and E by finger- tightening the thin screws 3 (4 × 12mm). 2-3 While pushing the lower part of D and E from outside, secure the bottom ends of B using two tapping screws 4 (4 × 20mm). 2-4 Insert the other two tapping screws 4 (4 × 20mm) into the other two screw holes to secure B. E 2-2 2-1 L L Headphone hanger set 4 × 10 mm thin screws ×2 5 Headphone hanger B Place the bottom ends of the rear panel on each foot. 2-3 2-4 D 2-3 32 34 CLP-220 Keyboard Stand Assembly