Yamaha MCP1 MCP1 Installation Manual - Page 11

Installation The MCP1 can be installed on a wall in either of two ways: in a gang box that is embedded behind the wall, or in the included surface mount box which you attach to the surface of the wall in an exposed position. CAUTION Install the MCP1 no more than 2 meters above the floor. When MCP1 falls, it becomes a cause by which MCP1 is damaged or you or others are injured. If embedding the unit in a gang box installed behind the wall Orient the gang box behind the wall in a horizontal position; into the gang box, pass the cable that is connected to the PSE. If installing the unit in the included surface mount box exposed on the surface of the wall The surface mount box has a cut-out that allows you to open a hole through which to pass the cable. Open the hole in the cutout as necessary with a tool (such as a plier), pass the cable into the surface mount box, and secure it using M4.0 flat head screws which you provide. 1. Attach the mounting plate to the gang box or the surface mount box. Orient it so that the side printed "TOP" is toward yourself and above. 1- a. If using a gang box Align the elongated holes of the mounting place with the screw holes of the gang box, and secure it in at least two locations. Mounting plate Gang box 1- b. If using a surface mount box Use the included screws without washers (M3.0 × 12). Mounting plate Surface mount box Cable MCP1 Installation Manual 11