Yamaha MCP1 MCP1 Installation Manual - Page 14

Removal, Initializing the MCP1

Get Yamaha MCP1 PDF manuals and user guides View all Yamaha MCP1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Removal If you need to remove the MCP1, insert a slotted screwdriver into the notches of the side panel, and twist. The subsequent steps are the reverse of the installation procedure. NOTE When re-installing the MCP1, portions of the screw holes in the mount plate may be deformed and may not properly fit into the MCP1. If this is the case, use a tool to adjust parts of the screw holes as necessary and re-install the unit. Initializing the MCP1 With the unit powered on, perform the following procedure. 1. In the home page or another page, long-touch (two seconds or longer) the home page switch. Move to the utility page. 2. Touch the [Settings] switch (R1). After synchronizing with MTX-MRX Editor, it will be necessary to enter the PIN code. NOTE If you have forgotten the PIN code, use MTX-MRX Editor to specify it again. 3. Touch the [Initialize] switch (L3). A confirmation screen appears; select Yes. Initialization begins, and the MCP1 automatically restarts. 14 MCP1 Installation Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
14
MCP1 Installation Man
u
al
Removal
If yo
u
need to remo
v
e the MCP1, insert a slotted scre
w
dri
v
er into the notches of the side
panel, and t
w
ist. The s
ub
seq
u
ent steps are the re
v
erse of the installation proced
u
re.
Initializing the MCP1
With the
u
nit po
w
ered on, perform the follo
w
ing proced
u
re.
1.
In the home page or another page, long-touch (two seconds or longer) the home
page switch.
Mo
v
e to the
u
tility page.
2.
Touch the [Settings] switch (R1).
After synchronizing
w
ith MTX-MRX Editor, it
w
ill
b
e necessary to enter the PIN code.
3.
Touch the [Initialize] switch (L3).
A confirmation screen appears; select Yes. Initialization
b
egins, and the MCP1 a
u
tomati-
cally restarts.
NOTE
When re-installing the MCP1, portions of the scre
w
holes in the mo
u
nt plate may
b
e deformed and may not
properly fit into the MCP1. If this is the case,
u
se a tool to adj
u
st parts of the scre
w
holes as necessary and
re-install the
u
nit.
NOTE
If yo
u
ha
v
e forgotten the PIN code,
u
se MTX-MRX Editor to specify it again.