Yamaha MOTIF7 Owner's Manual - Page 286
Installing the mLAN8E, fasten the flat ribbon cable to the rear panel of
View all Yamaha MOTIF7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 286 highlights
Installing Optional Hardware Flip over the AIEB2 taking care not to bend or damage the flat ribbon cable. AIEB2 Installing the mLAN8E 1 Using the same procedure as in steps 1 - 4 of "Installing the AIEB2" above, remove the cover on the underside of the MOTIF, then remove the cover of the mLAN/I/O expansion bay. 2 Remove the mLAN8E from its package and connect the included flat ribbon cable. Securely fasten the flat ribbon cable to the rear panel of the mLAN8E. Make sure that the ribbon is at the bottom, as shown. Top of mLAN8E 10 Let the ribbon cable fall into place between the AIEB2 and the circuit board of the MOTIF. Underside of the MOTIF Slide the flat ribbon cable in the space between the MOTIF and the AIEB2. Make sure that flat ribbon cable is at bottom of connector. Rear panel of mLAN8E m-LAN CN5 AIEB2 Underside of the MOTIF m-LAN CN5 Rear panel of the MOTIF Front panel of mLAN8E Make sure the flat ribbon cable sticks out from the bottom and that the panel printing "mLAN8E" can be seen. 3 Hold the mLAN8E upside down, and insert the connector on the other end of the flat ribbon cable, to the circuit board of the MOTIF. AIEB2 Rear panel of the MOTIF 11Re-install the cover you removed in earlier steps, in reverse order. Align the connectors as shown. Underside of the MOTIF m-LAN CN5 Appendix 286 MOTIF Appendix Underside of mLAN8E Rear panel of the MOTIF Front panel of mLAN8E (This example illustration shows the MOTIF6/MOTIF7.)