Yamaha NS-AP2600 Owners Manual - Page 5

Positioning the center speaker, Wall mounting for the center speaker - set up

Get Yamaha NS-AP2600 PDF manuals and user guides View all Yamaha NS-AP2600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

Positioning the center speaker Place the center speaker on top of the TV, on the floor in front of the TV, or inside the TV rack so that it is stable. When placing the speaker on top of the TV, put the provided fasteners at four points on both the bottom of the speaker and on top of the TV to prevent the speaker from falling. Speaker on top of the TV TV set Speaker inside the TV rack Fasteners 1 2 Notes Do not place the speaker on top of the TV if the area is smaller than the bottom area of the speaker. The speaker may fall and might cause personal injury. Though this speaker is a magnetically shielded type, there may be some influence on a TV picture depending on the type of TV or the placement of the speaker. In such a case, place the speaker apart from the TV so that there is no influence on the TV picture. Wall mounting for the center speaker 2-3/8" (60 mm) 5-3/4" (145 mm) You can also use the screw holes on the back of the speaker for installing the speakers on commercially available speaker brackets. A screw with a diameter of 1/4" can be used (Hole depth: 9/32") Tapping screw (Available at the hardware store) Min 1" 3/8" Wall / wall support When using speaker brackets to mount the speakers on a wall or celling, it is strongly recommended that safety wire, which may be included with the bracket, be used between the speaker and the bracket to prevent the speaker from falling. Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting bracket on the protruding screws. Make sure that the screws are securely caught by the narrow sections of the "key hole" opening. WARNING The center speaker weighs 2.6 lbs (1.2 kg). Do not mount the speaker on thin plywood or wall with soft surface material, since the screws may pull away from the surface and fall. This will damage the speaker and can cause personal injury. Do not install the speaker to a wall with nails, adhesives, or any other unstable hardware. Long-term use and vibrations may cause them to fall. To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor molding. Secure installation is the purchaser's responsibility. 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
5
z
Positioning the center speaker
Place the center speaker on top of the TV, on the floor in front of the TV, or inside the TV rack so that it is stable.
When placing the speaker on top of the TV, put the provided fasteners at four points on both the bottom of the
speaker and on top of the TV to prevent the speaker from falling.
Notes
z
Do not place the speaker on top of the TV if the area is smaller than the bottom area of the speaker. The
speaker may fall and might cause personal injury.
z
Though this speaker is a magnetically shielded type, there may be some influence on a TV picture depending
on the
type of
TV or the placement of the speaker. In such a case, place the speaker apart from the TV so
that there is no influence on the TV picture.
z
Wall mounting for the center speaker
Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting
bracket on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the “key hole” opening.
WARNING
z
The center speaker weighs 2.6 lbs (1.2 kg). Do not mount the speaker on thin plywood or wall with soft
surface material, since the screws may pull away from the surface and fall. This will damage the speaker and
can cause personal injury.
z
Do not install the speaker to a wall with nails, adhesives, or any other unstable hardware. Long-term use and
vibrations may cause them to fall.
z
To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor
molding.
z
Secure installation is the purchaser's responsibility.
Speaker on top of the TV
Speaker inside
the TV rack
TV set
Min
1”
3/8”
Tapping screw
(Available at the hardware store)
Wall / wall support
When using speaker brackets to mount the speakers on a wall or celling, it is strongly recommended
that safety wire, which may be included with the bracket, be used between the speaker and the
bracket to prevent the speaker from falling.
5-3/4” (145 mm)
2-3/8” (60 mm)
A screw with a diameter of 1/4” can be
used
(Hole depth: 9/32”)
You can also use the screw holes on
the back of the speaker for installing
the speakers on commercially
available speaker brackets.
1
2
Fasteners