Yamaha NS-P236 Owner's Manual - Page 15

English USING THE SUBWOOFER (YST-SW005) Ⅵ Controls and their functions SUBWOOFER SYSTEM YST-SW005 1 Port Front panel Rear panel 2 POWER ON OFF 3 110V-120V 220V-240V VOLTAGE SELECTOR VOLUME AUTO STANDBY HIGH LOW OFF 0 10 HIGH LOW HIGH CUT INPUT2 /MONO INPUT1 FROM AMPLIFIER OUTPUT TO SPEAKERS POWER ON OFF 220V-240V 110V-120V VOLTAGE SELECTOR 4 5 VOLUME AUTO STANDBY HIGH LOW OFF 0 10 HIGH LOW HIGH CUT 8 9 INPUT2 /MONO 6 INPUT1 FROM AMPLIFIER 7 OUTPUT TO SPEAKERS 1 Power indicator Lights up GREEN when the POWER switch (2) is pressed in to the ON position and goes off when set to the OFF position. * Standby mode If the POWER switch (2) is pressed in to the ON position and the AUTO STANDBY switch (4) is set to the HIGH or LOW position, this indicator lights up RED when no signal is received by the subwoofer. 2 POWER switch Press this switch to the ON position to turn on the power of the subwoofer. When the power of the subwoofer is on, the power indicator (1) on the front panel lights up GREEN. Press this switch again to set to the OFF position to turn off the power of the subwoofer. 3 VOLTAGE SELECTOR switch (For China, Korean and General models) If the preset setting of the switch is incorrect, set the switch to the proper voltage range (220V-240V or 110V-120V) of your area. Consult your dealer if you are unsure of the correct setting. WARNING Be sure to unplug the subwoofer before setting the VOLTAGE SELECTOR switch correctly. 4 AUTO STANDBY (HIGH/LOW/OFF) switch This switch is originally set to the OFF position. By setting this switch to the HIGH or LOW position, the subwoofer's automatic power-switching function operates as explained on page 9. If you do not need this function, set to the OFF position. * Make sure to change the setting of this switch only when the POWER switch (2) is in the OFF position. 5 INPUT2 terminals Used to input line level signals from the amplifier. 6 INPUT1 (FROM AMPLIFIER) terminals Used to connect the subwoofer with the speaker terminals of the amplifier. 7 OUTPUT (TO SPEAKERS) terminals Can be used for connecting to the main speakers. Signals from the INPUT1 terminals (6) are sent to these terminals. 8 VOLUME control Adjusts the volume level. Turn the control clockwise to increase the volume, and counterclockwise to decrease the volume. 9 HIGH CUT (HIGH/LOW) switch Selects the high frequency cut off point. Normally, it is set to LOW, however, you may set to HIGH if necessary. Refer to page 12-13. E-11