Yamaha P-100 Owner's Manual (image) - Page 63
Midi Data Format
View all Yamaha P-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
MIDI DATA FORMAT 1. Midi Transmission/Reception Block Diagrams 1.1 Reception Flow Diagram 2. Channel Messages 2.1 Transmission 2.1.1 Note On/Off Transmitted note range: 21 (A-1)~108 (C7) Velocity range: 0~127 (0 = note off) The transmitted note number value can be adjusted within the range from 0 (C-2) to 127 (G8) using the MIDI Tch and Tch+l transpose settings. 2.1.2 CONTROL CHANGE The P-100's controllers transmit MIDI data as described in the table below. 1.2 Transmission Flow Diagram 54 2.1.3 PITCH BEND Pitch bend messages are transmitted with 7-bit resolution. 2.1.4 AFTERTOUCH Aftertouch messages are transmitted by the CS slider or the foot controller when these controllers are assigned to the aftcrtouch function. 2.1.5 PROGRAM CHANGE Program change messages arc transmitted on the transmit channel (Tch) as specified by the program change transmit table when a main voice is selected in any mode. Program change messages arc transmitted on the sub voice transmit channel (Tch+l) according to the program change transmit table settings when the Split mode sub voice is selected. No program change message is transmitted when the Dual mode sub voice is selected. 2.1.6 CHANNEL MODE No channel mode messages are transmitted. 2.2 RECEPTION 2.2.1 NOTE ON/OFF Transmitted note range: 0 (C-2)~127 (G8) Velocity range: 1~127 Note numbers below 21 (A-1) are played as the corresponding note of the lowermost octave (A-l to G#0). Note numbers above 108 (C7) are played as the corresponding note of the uppermost octave (C#6 to C7). Velocity is received for note on messages only. 2.2.2 CONTROL CHANGE The parameters in the table control arc controlled by received control change messages. 2.2.3 PITCH BEND Pitch is controlled by the MSB of received pitch bend messages only. 2.2.4 AFTERTOUCH Aftertouch messages arc not recognized.