Yamaha P-85S Owner's Manual - Page 24

ENGLISH Recording Your Performance 4. Press either [REC] or [PLAY] button to stop record- ing. When recording is stopped, the [REC] lamp and the [PLAY] lamp flash to indicate that the recorded data is being saved to the instrument automatically. After the data is saved, the [REC] lamp will turn off and the [PLAY] lamp will light. CAUTION Do not turn off the power of the instrument when the lamps are flashing. Doing so may prevent saving of the song data which you have recorded. The user song recorder records the following data: Data in addition to the notes and voices you play is recorded. • Notes played • Voice selection • Pedal (Sustain/Soft/Sostenuto) • Reverb depth • Dual mode voices • Dual balance • Dual octave shift • Tempo • Reverb type (including OFF) NOTE Both the [REC] lamp and the [PLAY] lamp will begin to flash when the recorder memory is almost full. If the memory becomes full, recording will stop automatically. (All recorded data up to that point will be retained.) NOTE You can save the recorded data to a computer. You can also load the recorded data back from a computer and play it back on this instrument (page 27). Play back the recorded performance Press the [PLAY] button to play back the recorded performance. To stop playback in the middle of a song, press the [PLAY] button again. While holding down the [METRONOME] button, use the TEMPO [g]/[h] but- tons to change the playback tempo. NOTE Pressing the [REC] button to start recording, then pressing the [PLAY] button to stop recording will erase all previously- recorded data. NOTE You cannot re-record in the middle of a song. 22 24 P-85 Owner's Manual