Yamaha PF-500 Owner's Manual - Page 100
Assembling the Keyboard Stand
View all Yamaha PF-500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Assembling the Keyboard Stand You can use the PF-500 without installing the stand. However, if you wish to attach the stand to the PF-500, follow the steps below. CAUTION • Be careful not to confuse parts. Make sure that you install all parts in the correct orientation. Assemble the stand in accordance with the steps below. • At least two persons should assemble the stand together. • Be sure to use the correct-size screws, as indicated below. Use of incorrect screws can cause damages to the stand. • When you attach each part, be sure to tighten all screws. • Reverse the assembly procedure to disassemble the stand. Use the included wrench. Keyboard Remove the following parts from the package. Plate Stand Rear left leg Front left leg Rear right leg Front right leg Pedal unit AC power cord Screws Long screws (6x65mm) x 8 Short screws (6x20mm) x 8 Cord holders x 2 1. Attaching the front legs to the stand. 1 Place the stand on the floor so that the bottom side (with smaller holes) faces up. 2 2 Use a short screw to attach the bracket of the 3 front right leg to the bot- tom side of the stand. 3 Use two long screws to fix the bracket of the front right leg to the front side of the stand. 4 Attach the front left leg in the same way. 2. Attaching the rear legs to the stand. 1 2 3 Attach the rear right leg in the same way. 1 Use a short screw to attach the bracket of the rear left leg to the bottom side of the stand. 2 Use two long screws to fix the bracket of the rear left leg to the rear side of the stand. 3. Attaching the plate. Align the holes on the plate with the holes of the rear side of the bracket on the rear legs, then fix them using four short screws. Cap bolts x 4 100 PF-500 Wrench x 1