Yamaha RXV363-B Owners Manual - Page 16
Setting the speaker impedance (U.S.A. and Canada models only), Connecting to the FRONT A terminals
UPC - 940356709649
View all Yamaha RXV363-B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Connections ■ Connecting to the FRONT A terminals 2 1 Red: positive (+) Black: negative (-) 3 Setting the speaker impedance (U.S.A. and Canada models only) Caution If you are to use 6 ohm speakers, set "SP IMP." to "6ΩMIN" as follows BEFORE using this unit. 1 Loosen the knob. 2 Insert the bare end of the speaker wire into the slit on the terminal. 3 Tighten the knob to secure the wire. Connecting the banana plug (except Europe, Russia, Korea, and Asia models) The banana plug is a single-pole electrical connector widely used to terminate speaker cables. First, tighten the knob and then insert the banana plug connector into the end of the corresponding terminal. 1 Make sure this unit is turned off. See page 19 for details about turning on or off this unit. 2 Press and hold JTONE CONTROL and then press ASTANDBY/ON to turn on this unit. This unit turns on, an the advanced setup menu appears in the front panel display. 3 Press KPROGRAM l / h repeatedly to select "SP IMP.". The following display appears in the front panel display. Banana plug SP IMP.- 8 MIN ■ Connecting to the FRONT B, CENTER, and SURROUND terminals 4 Press LSTRAIGHT repeatedly to select "6ΩMIN". The following display appears in the front panel display. Red: positive (+) Black: negative (-) 1 Press down the tab. 2 Insert the bare end of the speaker wire into the hole on the terminal. 3 Release the tab to secure the wire. SP IMP.- 6 MIN 5 Press ASTANDBY/ON to confirm your selection and set this unit to the standby mode. Note The setting you made is reflected next time you turn on this unit. 12 En