Yamaha RXV363-B Owners Manual - Page 23
Connecting the FM and AM antennas, Connecting the power cable, Turning on and off the power
UPC - 940356709649
View all Yamaha RXV363-B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
PREPARATION Connecting the FM and AM antennas Both FM and AM indoor antennas are supplied with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals. Notes • The AM loop antenna should be placed away from this unit. • A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized Yamaha dealer or service center about outdoor antennas. • The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit. Outdoor AM antenna Use a 5 to 10 m (16 to 32 ft) of vinyl-covered wire extended outdoors from a window. AM loop antenna (supplied) Connections Assembling the supplied AM loop antenna Note The types of the supplied AM loop antenna is different depending on the models. Connecting the power cable Once all connections are complete, plug the power cable into the AC wall outlet. ANTENNA DEO N DVR OUT MONITOR OUT AM GND Indoor FM antenna (supplied) FM 75 UNBAL. R SURRO AUDIO N DVR OUT CD IN MD/ OUT (PLAY) CD-R (REC) OUTP S Ground For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth. Power cable (U.S.A. model) To the AC wall outlet Turning on and off the power ■ Turning on this unit Connecting the wire of the AM loop antenna Open the lever Insert Close the lever Press ASTANDBY/ON (or D POWER) to turn on this unit. y When you turn on this unit, there will be a 4 to 5-second delay before this unit can reproduce sound. ■ Set this unit to the standby mode y The wire of the AM loop antenna does not have any polarity and you can connect either end of the wire to AM or GND terminal. Press ASTANDBY/ON (or E STANDBY) to set this unit to the standby mode. Note In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control. English 19 En