Yamaha YAS-101 Owners Manual - Page 13
Operation by the TV remote control is, difficult with unit beneath/under TV - on with tv
View all Yamaha YAS-101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
English Operation by the TV remote control is difficult (with unit beneath/under TV) TV remote control operation may be difficult if the unit hides the sensor of your TV when beneath or under the TV. Try the two solutions below and see whether this solves the problem. 1 Move the unit in all directions. 2 Remove the stands to lower the height of the unit. Use a + driver to remove the screws. The unit will be 19 mm lower without the stands. Additional Information 2 Press both the VOLUME + button and button of the main unit, release the button first, then release the VOLUME + button. The unit is turned on when switching the TV remote control signal transmission function on/off. The CLEAR VOICE indicator lights up as the following illustration. Check if the setting is correct. (☞ P. 11) The CLEAR VOICE indicator (for 2 seconds after the unit is turned on) On No light Off Green • The default setting is off. • You can verify the current setting by turning the unit on again from standby mode. Note Keep the stands and screws in a safe place for future use. Notes • Move the unit in all directions again if TV remote control remains difficult. • The TV remote control signal transmission function is enabled even if the unit is in standby mode. Using TV remote control signal transmission function Operate the unit by TV remote control (TV remote control learning function) If you cannot solve the problem by the suggestions above, follow the procedure below and use the TV remote control signal transmission function, which transmits the TV remote control signal received at the front of the unit to the remote control sensor of your TV through the IR flasher at the rear of the unit. The remote control sensor of your TV IR flasher 1 Set the unit to standby mode. You can use the TV remote control solely to operate by having the unit learn the TV remote control operations. You can operate the following functions by TV remote control. • Volume down • Volume up • Power on/standby mode y Some TV remote controls may not control these functions. Use the remote control supplied with the unit in this case. 1 Set the unit and TV to standby mode. 2 Press both the INPUT button and button of the main unit, release the button first, then release the INPUT button. The unit enters the remote control learning mode. Flashes in red Continued to the next page. \ 9 En