Yamaha YDP-C71 Owner's Manual - Page 28
Keyboard Stand Assembly
View all Yamaha YDP-C71 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
ENGLISH Appendix Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Assemble the unit on a hard and flat floor with ample space. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of each unit. • To disassemble, reverse the assembly sequence given below. 1 Attach (finger-tighten) C to D and E. Have a Phillips-head (+) screwdriver of the appropriate size ready. 1-1 Untie and straighten out the bundled pedal cord. Don't discard the vinyl tie. You will need it later in step 6. Remove all parts from the package and make sure you have all of the items. A 1-2 Align D and E with each end of C. 1-3 Attach D and E to C by finger-tightening the long screws 1 (6 20mm). D B E E 1-2 C Bundled pedal cord inside AC Power cord Assembly Parts 1 6 20 mm long screws 4 4 4 20 mm tapping screws 4 2 6 16 mm short screws 4 5 Cord holders 2 3 4 12 mm thin screws 2 Headphone hanger set 6 4 10 mm thin screws 2 Headphone hanger D C 1-3 1-1 2 Attach B. 2-1 Place the lower side of B on each foot of D and E, then attach the upper side to D and E. 2-2 Attach the top of B to D and E by finger-tightening the thin screws 3 (4 12mm). 2-3 While pushing the lower part of D and E from outside, secure the bottom ends of B using two tapping screws 4 (4 20mm). 2-4 Insert the other two tapping screws 4 (4 20mm) into the other two screw holes to secure B. L 28 YDP-C71 Owner's Manual