Yamaha YDP-S51 Owner's Manual - Page 28

ENGLISH Appendix Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Assemble the unit on a hard and flat floor with ample space. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of each unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver of the appropriate size ready. 1 Attach (finger-tighten) C to D and E. 1-1 Untie and straighten out the bundled cord. Don't discard the vinyl tie. You will need it later in step 6. Remove all parts from the package and make sure you have all of the items. A D B E C Bundled pedal cord inside AC Power adaptor * The two anti-fall brackets are identical. (Either one can be used for left or right.) * The adaptor may not be included, or may look different from the illustration above, depending on your particular area. Please check with your Yamaha dealer. Assembly Parts 1 6 x 25 mm long screws x 4 5 4 x 20 mm tapping screws x 2 2 6 x 20 mm long screws x 2 6 Caps x 2 1-2 Align D and E with each end of C. 1-3 Attach D and E to C by finger-tightening the long screws 2 (6 x 20 mm). 1-2 C D E 1-3 2 Attach B. 2-1 Attach the top of B to D and E by finger-tightening the thin screws 4 (4 x 12 mm). 2-2 While pressing on the lower part of D and E from the outside, attach the anti-fall brackets and then secure the bottom ends of B using four long screws 1 (6 x 25 mm). 2-3 Insert the other two tapping screws 5 (4 x 20 mm) into the other two screw holes to secure B. 3 6 x 16 mm short screws x 4 7 Cord holders x 2 4 4 x 12 mm thin screws x 2 8 Anti-fall brackets x 2 28 YDP-S51 Owner's Manual