Yamaha YDP-S51 Owner's Manual - Page 29
Secure C., Mount A., Connect the pedal cord., CAUTION
View all Yamaha YDP-S51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
ENGLISH 2-4 Securely tighten the screws on the top of B that were attached in Step 2-1. E 2-1, 2-4 B D 2-2 2-3 2-2 Appendix 5 Secure A. 5-1 Adjust the position of A so that the left and right ends of A will project beyond D and E equally when seen from the front. 5-2 Secure A by tightening the four short screws () (6 x 16 mm) from the bottom. 5-1 A Projection of A A Secure the anti-fall brackets using the screws. 3 Secure C. 3-1 Securely tighten the screws on C that were attached in Step 1-3. 3-2 Attach the caps () to the head of the screws. 3-2 D B D C 3-1 4 Mount A. Be sure to place your hands at least 10 cm from either end of A when positioning it. At least 10 cm At least 10 cm 5-2 6 Connect the pedal cord. 6-1 Insert the pedal cord plug to the [TO PEDAL] jack from the rear. 6-2 Attach the cord holders to the rear panel as shown, then clip the cord into the holders. 6-3 Use a vinyl tie to take up any slack in the pedal cord. 6-1 A 6-2 D B E Align the dowels on D and E with the corresponding holes on the bottom of A. CAUTION • Be careful not to pinch your fingers or drop the unit. • Do not hold the keyboard in any position other than the position shown in the illustration. 6-3 Insert the pedal cord securely until the metal part of the cord plug disappears from view. Otherwise, the pedal may not function properly. Insert the cord all the way until the metal part of the plug disappears from view. YDP-S51 Owner's Manual 29