Zanussi ZKG7165 Product Manaul - Page 20

Replace the drawer and run the rinse programme without any clothes in the drum. Cleaning the pump The pump should be inspected regularly and particularly if: • the appliance does not empty and/or spin; • the appliance makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump; • a problem with water draining is detected (see chapter "What to do if..." for more details). Warning! 1. Disconnect the mains plug from the mains socket. 2. Do not remove the filter while the appliance operates. Do not clean the drain pump if the water in the appliance is hot. The water must be cold before you clean the drain pump. Proceed as follows: When the container is full of water, put the drainage duct back again and empty the container. Do steps 3 and 4 again and again until no more water flows out from the drain pump. 1 2 Pull back the drainage duct. Unscrew the filter and remove it. Open the pump door. Put a container below the recess of the drain pump to collect the water that flows out. Remove fluff and objects from the pump. Press the two levers and pull forward the drainage duct to let the water flow out. 20 Make sure that the impeller of the pump can turn. If this does not occur, contact the service centre. www.zanussi.com