Zanussi ZWJ14591W Product Manaul - Page 14

Important! • The selected delay can be changed only af- ter selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing button 7 and wait a few minutes before opening the door. After you have closed the door, press the same button again. Important! The Delay Start cannot be selected with the draining programme. Altering an option or a running programme It is possible to change some options before the programme carries them out. Before you make any change, you must pause the washing machine by pressing button 7. Changing a running programme is possible only by resetting it. Turn the programme selector dial to and then to the new programme position. Start the new programme by pressing button 7 again. The washing water in the tub will be not emptied out. Interrupting a programme Press the button 7 to interrupt a programme which is running, the corresponding pilot light starts blinking. Press the button again to restart the programme. Cancelling a programme Turn the selector dial to to cancel a programme which is running. Now you can select a new programme. Opening the door after the programme has started First set the machine to pause by pressing the button 7. If the pilot light 9 blinks and after a few minutes goes off, the door can be opened. If the pilot light 9 remains lit, this means that the machine is already heating or that the water level is too high. In any case, do not try to force the door open! If you cannot open the door but you need to open it, you have to switch the machine off by turning the selector dial to . After a few minutes the door can be opened. (Pay attention to the water level and temperature!). After closing the door, it is necessary to select the programme and options again and to press button 7. At the end of the programme The machine stops automatically. Three blinking appear on the display. The light of button 7 and, after a few minutes, the light 9 go off. If you have set a programme or an option that ends with water left in the tub, the light 9 remains on. The door is locked. It is necessary to empty out the water before opening the door. During this time, the drum continues to run at regular intervals until the water draining. Follow the below instructions to empty out the water: 1. Turn the programme selector dial to . 2. Select the draining or spinning programme. 3. Reduce the spin speed if needed, by pressing the relevant button. 4. Press button 7. At the end of the programme, after a few minutes the door is released and can be opened. Turn the programme selector dial to to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is reduced. By pressing any button the appliance will come out of the energy saving status. 14 www.zanussi.com