Zanussi ZWJ14591W Product Manaul - Page 16

Open the pump door. Put a container below the recess of the drain pump to collect the water that flows out. Press the two levers and pull forward the drainage duct to let the water flow out. Make sure that the impeller of the pump can turn. If this does not occur, contact the service centre. 1 2 When the container is full of water, put the drainage duct back again and empty the container. Do steps 3 and 4 again and again until no more water flows out from the drain pump. Clean the filter under the water tap and put it back in the pump into the special guides. Make sure that you tighten correctly the filter to prevent leakages. 1 2 Pull back the drainage duct. Unscrew the filter and remove it. Remove fluff and objects from the pump. 16 Close the pump door. Caution! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When refitting the pump cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it. Cleaning the water inlet filters www.zanussi.com