Zenith SL-5512-BZ-B User Guide - Page 1

DualBrite® Twin Halogen Motion Sensing Light Model SL-5512 Requirements • The light control requires 120-volts AC. • If you want to use Manual Mode, the control must be wired through a switch. • Some codes require installation by a qualified electrician. • This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations. Features • Turns on lighting when motion is detected. • Automatically turns lighting off. • DualBrite® Timer. • Photocell keeps the lighting off during daylight hours. • LED indicates motion was sensed (day or night). This package includes: OPERATION Mode: Test Auto Manual Accent On-Time 5 Seconds 1, 5, or 20 Min To Dawn* 3, 6 Hr, to Dawn Works: Day Night xx x x x * resets to Auto Mode at dawn. Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate. Rubber Plug Plastic Hanger Cover Plate 6 Mounting Screws (3 sizes) TEST Put ON-TIME switch ON-TIME on the sensor bottom to TEST and the DualBrite® switch OFF. TEST 1 5 20 DualBrite® Off 3 6 Dusk to Dawn Sensor Light Control 3 Wire Connectors AUTO Put the ON-TIME switch in the 1, 5, or 20 minute position. ON-TIME TEST 1 5 20 Mounting Bolt Mounting Strap Gasket 2 Halogen Bulbs Light Shield MANUAL MODE Manual mode only works at night because daylight returns the sensor to AUTO. Flip the light switch off for one second then back on to toggle between AUTO 1 Second OFF and MANUAL MODE. then... Manual mode works only with the ON-TIME switch in the 1, 5, or 20 position. ... back on. © 2008 HeathCo LLC 595-5575-09