Zenith SL-5512-BZ-B User Guide - Page 3
Mount the Light Control, Bulb Installation, Wire the Light Control
UPC - 016963551206
View all Zenith SL-5512-BZ-B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Bulb Installation Mount the Light Control NOTE: Lamps are included, but you will need to install ❒ Place the mounting bolt through the front of the them junction box cover. Push the small gasket hole over NOTE: When re-lamping, turn power off and let the the mounting bolt. fixture cool. ❒ Make sure the wire connectors and wires are inside ❒ Open glass covers. To remove the old bulb push the junction box. Align the mounting bolt with the the bulb towards the right until the left side of the center hole in the mounting strap. Secure the fixture bulb is clear of the left socket. to the mounting strap. ❒ To install a bulb, push the bulb into the right socket ❒ Push the rubber plug firmly into place. so the bulb fits completely into the left socket. ❒ Check that the bulb is seated properly. ❒ Close the glass covers. Mounting Bolt Wire the Light Control WARNING: Turn power off at circuit breaker or fuse. ❒ Remove the existing light fixture. ❒ Install mounting strap to junction box using screws appropriate for your junction box. Rubber Plug ❒ The plastic hanger can be used to hold the fixture while wiring. The small end of the plastic hanger can be threaded through the hole in the center of ❒ If not installed on a weatherproof box, caulk the the cover plate. The small end then goes into one wall plate and mounting surface with silicone. of the slots on the mounting strap. ❒ Adjust the lamp holders by loosening the lock nuts ❒ Thread all fixture wires through the large holes in but do not rotate the lamp holders more than 180° the gasket as shown. from the factory setting. ❒ Connect the junction box wires to the light fixture wires as shown. Twist together and secure with wire connectors. Push the rubber plug over the mounting bolt. CAUTION: Do not cut any wires with factory installed wire connectors. White to White Mounting Strap Keep lamps at least 1" (2.5 cm) from the sensor. Gasket Black to Black Connect green or bare copper wire(s) in the fixture to green ground screw and ground wire in junction box. Note: All ground wires shown as green in above illustration. 595-5575-09