Zenith SL-5525-WH User Guide - Page 1

Motion Sensing Halogen Fixture OPERATION Mode: Test Auto Manual On-Time 5 Seconds 1, 5, or 10 Min Until Dawn* Works: Day Night xx x x * resets to Auto Mode at dawn. Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate. Model SL-5525 Features • Turns on lighting when motion is detected. • Automatically turns lighting off. • Photocell keeps the lighting off during daylight hours. • LED indicates motion was sensed (day or night). This package includes: TEST Put the ON-TIME switch on the bottom of the sensor in the TEST position. ON-TIME 10 5 1 TEST AUTO Put the ON-TIME switch in the 1, 5, or 10 minute position. ON-TIME 10 5 1 TEST Plastic Hanger 6 Screws (3 sizes included) Gasket MANUAL MODE Manual mode only works at night because daylight returns the sensor to AUTO. 3 Wire Connectors 1 Halogen Lamp Sensor Mounting Strap Light Control Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE. 1 Second OFF then... Manual mode works only with the ON-TIME switch in the 1, 5, or 10 position. ... back on. Mounting Bolt Light Shield Rubber Plug Requirements • The light control requires 120-volts AC. • If you want to use Manual Mode, the control must be wired through a switch. • Some codes require installation by a qualified electrician. • This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations. Mode Switch Summary TEST Move ON-TIME Switch to 1, 5, or 10 minutes AUTO MANUAL MODE Flip light switch off for one second then back on* * If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode. © 2007 HeathCo LLC 595-5295-12