Zenith SL-5525-WH User Guide - Page 3

TEST AND ADJUSTMENT ❒ Turn on the circuit breaker and light switch. NOTE: Sensor has about 1 1/2 minutes warm up period before it will detect motion. When first turned on, wait about 1 1/2 minutes. ❒ Turn the RANGE control to the mid position and the ON-TIME control to the TEST position. ON-TIME RANGE 10 5 1 TEST MIN MAX Bottom of Sensor Avoid aiming the control at: • Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering. • Areas where pets or traffic may trigger the control. • Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the sensor. 8 ft. (2.4 m) 180° 70 ft. (21 m) Maximum Range Maximum Coverage Angle ❒ Loosen the clamp screw in the sensor ball joint and gently rotate the sensor. Clamp Screw ❒ Walk through the coverage area noting where you are when the lights turn on (also, the LED will Ball Joint flash several times when motion is detected). Move the sensor head up, down, or sideways to changethecoveragearea.Keep Aim Sensor the sensor at least 1" (2.5 Down for Short cm) away from the lamp. Coverage ❒ Adjust the RANGE as needed. RANGE set too high may increase false triggering. ❒ Secure the sensor head by tightening the clamp screw. Do not overtighten the screw. ❒ Set the amount of TIME you Aim Sensor Higher for Long Coverage want the lights to stay on after motion is detected (1, 5, or 10 minutes). SPECIFICATIONS Range Up to 70 ft. (21 m) [varies with surrounding temperature]. Sensing Angle Up to 180° Electrical Load Up to 250 Watts Maximum Incandescent. Power Requirements. . . 120 VAC, 60 Hz Operating Modes. . . . . . TEST, AUTO and MANUAL MODE Time Delay 1, 5, 10 minutes Replacement lamp. . . . . T3, 250W (or less) halogen 120 VAC HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold. The detector is most sensitive to motion across its field of view. Motion Motion Sensor Least Sensitive Most Sensitive 595-5295-12