ZyXEL P-2612HNU-F1 User Guide - Page 97
Broadband Add/Edit: Routing- PPPoE
View all ZyXEL P-2612HNU-F1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Chapter 5 Broadband The following table describes the fields in this screen. Table 7 Broadband Add/Edit: Routing- PPPoE Label DESCRIPTION General Name Enter a service name of the connection. Type Select an interface for which you want to configure here. ADSL: The ZyXEL Device uses the ADSL technology for data transmission over the DSL port. Mode WAN Service Type EtherWAN: The ZyXEL Device transmits data over the Ethernet WAN port. Select this if you have a DSL router or modem in your network already. Select Routing (default) from the drop-down list box if your ISP give you one IP address only and you want multiple computers to share an Internet account. This field is available only when you select Routing in the Mode field. Select the method of encapsulation used by your ISP. ATM PVC Configuration • PPP over Ethernet (PPPoE) - PPPoE (Point to Point Protocol over Ethernet) provides access control and billing functionality in a manner similar to dial-up services using PPP. Select this if you have a username and password for Internet access. • IP over Ethernet - In this type of Internet connection, IP packets are routed between the Ethernet interface and the WAN interface and then formatted so that they can be understood in a bridged environment. VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit. VPI VCI DSL Link Type Encapsulation Mode This section is available only when you select ADSL in the Type field to configure an ATM layer-2 interface. The valid range for the VPI is 0 to 255. Enter the VPI assigned to you. The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management of ATM traffic). Enter the VCI assigned to you. The DSL link type is set to EoA (Ethernet over ATM) to have an Ethernet header in the packet, so that you can have multiple services/ connections over one PVC. You can set each connection to have its own MAC address or all connections share one MAC address but use different VLAN IDs for different services. EoA supports IPoE, PPPoE and RFC1483/2684 bridging encapsulation methods. The encapsulation method of multiplexing used by your is LLC/SNAPBRIDGING. In LCC encapsulation, bridged PDUs are encapsulated by identifying the type of the bridged media in the SNAP header. P-2612HNU(L)-FxF User's Guide 97