ZyXEL P-792H User Guide - Page 71
Network > WAN > More Connections: Edit continued
View all ZyXEL P-792H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Chapter 6 WAN Setup Table 15 Network > WAN > More Connections: Edit (continued) LABEL DESCRIPTION Encapsulation Select the method of encapsulation used by your ISP from the drop-down list box. Choices vary depending on the mode you select in the Mode field. If you select Bridge in the Mode field, select either PPPoA or RFC 1483. If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or PPPoE. User Name Password Service Name Multiplexing If you set up a point-to-point connection, select either ENET ENCAP or RFC 1483. (PPPoA and PPPoE encapsulation only) Enter the user name exactly as your ISP assigned. If assigned a name in the form user@domain where domain identifies a service name, then enter both components exactly as given. (PPPoA and PPPoE encapsulation only) Enter the password associated with the user name above. (PPPoE only) Type the name of your PPPoE service here. Select the method of multiplexing used by your ISP from the drop-down list. Choices are VC or LLC. By prior agreement, a protocol is assigned a specific virtual circuit, for example, VC1 will carry IP. If you select VC, specify separate VPI and VCI numbers for each protocol. VPI VCI Line IP Address For LLC-based multiplexing or PPP encapsulation, one VC carries multiple protocols with protocol identifying information being contained in each packet header. In this case, only one set of VPI and VCI numbers need be specified for all protocols. The valid range for the VPI is 0 to 255. Enter the VPI assigned to you. The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management of ATM traffic). Enter the VCI assigned to you. Select the DSL line you want the P-792H v2 to use as a default for outgoing traffic (remote node 1). This option is available if you select Routing in the Mode field. A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed; the ISP assigns you a different one each time you connect to the Internet. If you use the encapsulation type except RFC 1483, select Obtain an IP Address Automatically when you have a dynamic IP address; otherwise select Static IP Address and type your ISP assigned IP address in the IP Address field below. Subnet Mask Gateway IP address Connection If you use RFC 1483, enter the IP address given by your ISP in the IP Address field. Enter a subnet mask in dotted decimal notation. Specify a gateway IP address (supplied by your ISP). P-792H v2 User's Guide 71