ZyXEL ZyWALL USG 50 User Manual - Page 98

Chapter 6 Configuration Basics 8 For the Next Hop fields, select Interface as the Type if you have a single WAN connection or Trunk if you have multiple WAN connections. 9 Select the interface that you are using for your WAN connection (wan1 and wan2 are the default WAN interfaces). If you have multiple WAN connections, select the trunk. 10 Specify the amount of bandwidth FTP traffic can use. You may also want to set a low priority for FTP traffic. Note: The ZyWALL checks the policy routes in the order that they are listed. So make sure that your custom policy route comes before any other routes that would also match the FTP traffic. 6.5.7 Static Routes Use static routes to tell the ZyWALL about networks not directly connected to the ZyWALL. MENU ITEM(S) Configuration > Network > Routing > Static Route PREREQUISITES Interfaces 6.5.8 Zones See Section 6.2 on page 88 for background information. A zone is a group of interfaces and VPN tunnels. The ZyWALL uses zones, not interfaces, in many security settings, such as firewall rules and remote management. Zones cannot overlap. Each interface and VPN tunnel can be assigned to at most one zone. Virtual interfaces are automatically assigned to the same zone as the interface on which they run. When you create a zone, the ZyWALL does not create any firewall rules, assign an IDP profile, or configure remote management for the new zone. MENU ITEM(S) Configuration > Network > Zone PREREQUISITES Interfaces, IPSec VPN, SSL VPN WHERE USED Firewall, IDP, remote management, anti-virus, ADP, application patrol Example: For example, to create the DMZ-2 zone, click Network > Zone and then the Add icon. 98 ZyWALL USG 50 User's Guide